Kutatásunk során két különböző gömbhéj mechanikai, geometriai és mikroszerkezeti vizsgálatát végeztük el a törőerő, geometriai tulajdonságok és anyagösszetétel meghatározása érdekében. A „01 globocer” típusú minták átmérője átlagosan 2,37 mm, a „03 globocer” típusú mintáké 6,88 mm, mindkettő kisebb a névleges méretnél, a körkörösségtől való eltérésük pedig rendre 8%, illetve 6%. A 01 globocer minták átlagos belső falporozitása 53±3%, a 03 globocer mintáké 56±3%. A gömbhéjak felülete egyenetlen, amely hatással van a nyomóterhelést átvevő felület méretére, így a törőerő értékekre is, amelyek 01 globocer gömbhéjaknál 42 N, a 03 globocer gömbhéjaknál pedig 288 N. A töréshez tartozó maximális erőértékek a 01 jelű gömbhéjaknál jobban függenek az átmérőtől, mint a 03 jelűeknél, előbbiben tendencia figyelhető meg
In this study two different types of hollow sphere were examined by mechanical, geometrical and microstructural measurements, and the fracture force, geometrical properties and chemical composition were determined. The diameter of the “01 globocer” type specimens was 2.37 mm on average, while the value for the “03 globocer” type specimens was 6.88 mm, both were smaller than the nominal diameter. The average deviation from the circularity of the “01 globocer” specimens was 8 %, the value for the “03 globocer” specimens was 6 %, while the average wall porosity was 53±3 % and 56±3 % respectively. The surface of the hollow spheres was uneven, which has an impact on the contact surfaces during pressure tests, which affects the fracture force values. The average value of the fracture force of “01 globocer” spheres was 42 N, and of “03 globocer” hollow spheres, the average was 288 N. The diameter had a bigger impact on the fracture force values of the type 01 specimens than in the case of 03.